3. Introduction
The XFree86 server allows users to configure their video
subsystem and thus encourages best use of existing hardware. This
document is intended to help you learn how to generate your own timing
numbers to make optimum use of your video card and monitor.
We'll present a method for getting something that works, and
then show you how you can experiment starting from that base to
develop settings that optimize for your taste.
If you already have a mode that almost works (in particular, if
one of predefined VESA modes gives you a stable display but one that's
displaced right or left, or too small, or too large) you can go
straight to the section on Fixing Problems with
the Image. This will enlighten you on ways to tweak the timing
numbers to achieve particular effects.
Don't assume that you need to get all the way into mode tuning
just because your X comes up with a scrambled display first time after
installation; it may be that most of the factory mode lines are OK and
you just happened to default to one that doesn't fit your
hardware. Instead, cycle through all your installed modes with
CTRL-ALT-KP+. If some of the modes look OK, try
commenting out all but a 640x480 and check that that mode works. If it
does then uncomment a couple of other modes, e.g. an 800x600 and a
1024x768 at a frequency that your monitor should be able to
handle.