Chapter 7. Proc pseudo file system
The proc pseudo file system provides some useful information about the
SCSI subsystem. The kernel configuration option that selects "proc_fs"
is CONFIG_PROC_FS and in almost all cases it should be selected. SCSI
specific information
is found under the directory /proc/scsi. Probably
the most commonly accessed entry is cat /proc/scsi/scsi
which lists the attached SCSI devices. See
Section 8.3 for more details.
The lower level drivers are allocated proc_fs entries of the form:
/proc/scsi/<driver_name>/<scsi_adapter_number>
|
where the <driver_name> is something like "aic7xxx" or "BusLogic". The
<scsi_adapter_number> (also known as the host number) is the same number
that was discussed in
Section 3.1. Note that one driver
may control one or more hosts.
What is stored in this file is lower level driver dependent (and in the
case of some adapter drivers it
is possible to set parameters via this file). When reporting problems
to newsgroups or maintainers it is useful to include the output of this
file (e.g.
cat /proc/scsi/aic7xxx/0 ).
The cdrom driver provides information about attached cdrom devices
in the /proc/sys/dev/cdrom directory. This will
include both SCSI devices (i.e. those controlled by the sr driver) and
IDE devices (i.e. those controlled by the ide-cd driver).
See Section 9.2.3.
The sg driver provides information about its state and attached hosts and
devices in the /proc/scsi/sg directory.
See Section 9.4.3.
More general information on the proc pseudo file system can be found in
the kernel source file:
/usr/src/linux/Documentation/filesystems/proc.txt.