11.1. Initializing disks or disk partitions
Before you can use a disk or disk partition as a physical volume
you will have to initialize it:
For entire disks:
Run pvcreate on the disk:
This creates a volume group descriptor at the start of
disk.
| Not Recommended |
---|
|
Using the whole disk as a PV (as opposed to a partition spanning the whole disk) is not recommended because of the management issues it can create. Any other OS that looks at the disk will not recognize the LVM metadata and display the disk as being free, so it is likely it will be overwritten. LVM itself will work fine with whole disk PVs.
|
If you get an error that LVM can't initialize a
disk with a partition table on it, first make sure
that the disk you are operating on is the correct
one. If you are very sure that it is, run the
following:
| DANGEROUS |
---|
|
The following commands will destroy the
partition table on the disk being operated on.
Be very sure it is the correct disk.
|
# dd if=/dev/zero of=/dev/diskname bs=1k count=1
# blockdev --rereadpt /dev/diskname
|
For partitions:
When using LVM 1 on PCs with DOS partitions, set
the partition type to 0x8e using fdisk or some
other similar program. This step is unnecessary
on PPC systems or when using LVM 2.
Run pvcreate on the partition:
This creates a volume group descriptor at the start of
the /dev/hdb1 partition.
|
|